Differences

This shows you the differences between two versions of the page.

--- easymesh:tplink [2023/12/18 22:10] – created olaf
+++ easymesh:tplink [2023/12/18 23:01] (current) – created olaf
@@ Line 1: / Line 1: @@
-====== EasyMesh with TP-Link AX55======
+===== EasyMesh with TP-Link AX55 =====
+<WRAP column>{{:ax55-large.jpg}}</WRAP>
+<WRAP column>
+<WRAP round notice>//**__This is related to hardware version v1.0__**//\\
+For ethernet backhaul to work Beta firmware 1.2.6 is required.\\
+It can be found at https://community.tp-link.com/en/home/forum/topic/636954</WRAP>
+</WRAP>
+<WRAP clear></WRAP>
+==== Setup =====
+Step 1 ...
+Step 2 ...
+Step x ...
+==== Ethernet backhaul ====
+With firmware 1.2.6 installed, there is not much more to do than to connect the second AX55 to the Mesh Master.\\
+But, when the Mesh Master is configuring the mesh with ethernet backhaul, it creates a loop for about 1 to 2 seconds.
+This is a problem if there are switches in the network that have loop protection (some devices have STP) enabled.
+Therefore, it is important to disable loop protection.
+Once the secondary mesh node is connected and recognized, it will switch to wired mode and reboot.
+The Mesh Master node will reboot too.
-This is related to hardware version v1.0
-For ethernet backhaul to work Beta firmware 1.2.6 is required. It can be found at https://community.tp-link.com/en/home/forum/topic/636954

OOKB - Olaf's Own Knowledge Base