OOKB - Olaf's Own Knowledge Base

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

===== EasyMesh with TP-Link AX55 ===== 
<WRAP column>{{:ax55-large.jpg}}</WRAP>
<WRAP column>
<WRAP round notice>//**__This is related to hardware version v1.0__**//\\
For ethernet backhaul to work Beta firmware 1.2.6 is required.\\
It can be found at https://community.tp-link.com/en/home/forum/topic/636954</WRAP>
</WRAP>
<WRAP clear></WRAP>

==== Setup =====

Step 1 ...

Step 2 ...

Step x ...


==== Ethernet backhaul ====

With firmware 1.2.6 installed, there is not much more to do than to connect the second AX55 to the Mesh Master.\\
But, when the Mesh Master is configuring the mesh with ethernet backhaul, it creates a loop for about 1 to 2 seconds.
This is a problem if there are switches in the network that have loop protection (some devices have STP) enabled.
Therefore, it is important to disable loop protection.

Once the secondary mesh node is connected and recognized, it will switch to wired mode and reboot.
The Mesh Master node will reboot too.

OOKB - Olaf's Own Knowledge Base

User Tools

Site Tools

Page Tools